How to Apply Wallpaper Correctly

Vinyl wallpaper are used primarily where durable surfaces are required. Especially in kitchen and bathroom, the wallpaper are popular. But even in the hallway you can find her application. The advantage of wallpaper: they are washable and abrasion. Dirt can easily be removed with a cloth or a soft brush.But vinyl wallpaper among the heavy wallpaper and are therefore often not easy to work with.Getting the wallpaper still on the wall, can be found here.

Look For A Good Base

Before you get down to decorating, you should check the ground exactly. Just vinyl wall coverings need a solid, clean, dry surface. Many vinyl wall coverings have a relatively smooth surface. Therefore, the surface should be smooth so that irregularities not locked. Substrates that suck strongly, make sure you pre-treat. A wallpaper primer ensures that the ground sucks less. Use in no case a Feinmakulatur. This is not suitable for vinyl wallpapers. If you want to make the ground with waste wallpapering done, then please only with a Rollenmakulatur. Rollenmakulatur is even the perfect base for vinyl wallpaper. Check INTERNETDICT for wallpaper making tips.

Use Only Suitable Paste

As wallpaper, vinyl wall coverings have a low water vapor permeability. Therefore, you should only use special paste. Put the paste in a ratio of 1:20. For difficult substrates, an addition of 20% dispersion adhesive can be useful. Keep in mind, though, that you want the wallpaper down again sometime.

And so The Wallpaper Is on The Wall

With vinyl wallpaper, you must already be careful when pasting. Place the paste on the wallpaper roll, put together this and roll the train again together. In order to prevent the edges line up and dry out. Vinyl wall coverings have a relatively long soaking time. Five to ten minutes should be soft lanes. The webs are attached edge to edge. With a wallpaper scraper you can easily smooth out air bubbles. For trimming you need a utility knife, scissors and a ruler trimming. Narrow margins can be better with the scissors.When cutter you should ensure that your blade is always sharp.

Excess glue, wipe with a damp cloth or sponge the same from, because otherwise this dries on the wallpaper and leaves unsightly spots.